Host System Integration - Emerson 5301HxxxxxxxxxxxxxxZZ Series Reference Manual

Reference Manual
00809-0100-4530
will also need the National Instruments Communication Manager software (see
the RRM software for FOUNDATION
5.3

Host system integration

5.3.1 Confirm system readiness (HART
Confirm HART
If using HART based control or asset management systems, confirm the HART capability of
those systems prior to transmitter installation. Not all systems are capable of
communicating with HART Revision 7 protocol.
Transmitters with a firmware version 2F0 or later can be configured for either HART
Revision 5 or 7.
Confirm correct device driver
Procedure
• Verify that the latest Device Driver (DD/DTM
proper communication. See
• Download the latest Device Driver from Emerson.com/DeviceInstallKits.
Table 5-1: Rosemount 5300 Device Revisions and Files
Firmware version
2F0 or later
2A2 - 2E0
(1)
(2)
Switch HART
If the HART configuration tool is not capable of communicating with HART Revision 7, the
device will load a generic menu with limited capability. To switch the HART revision mode
from the generic menu:
Procedure
1. Locate the "Message" field.
2. In the Message field, enter HART5 or HART7 and then 27 trailing spaces.
Reference Manual
®
revision capability
(1)
Firmware version is printed on the transmitter head label, e.g. SW 2E0 or can be found in
Rosemount Radar Master (select Device → Properties).
Device revision is printed on the transmitter head label, e.g. HART Dev Rev 4.
®
revision mode
Fieldbus).
®
only)
™
) is loaded on your systems to ensure
Table 5-1.
Find Device Driver
®
HART Universal Revision
7
5
5
Configuration
April 2019
Installing
(2)
Device Revision
4
3
3
115