How To Display The Hardware Bypass Status Of A Static Party - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 8 Configuring the Connection

How to Display the Hardware Bypass Status of a Static Party

From the SCE(config)#> prompt, type:
Command
show party name party-name hw-bypass
The hardware bypass action can be performed only on the static parties created in the hardware bypass
Note
mode.
The following example shows how to display the hardware bypass of a specified static party:
SCE>enable 15
Password:<cisco>
SCE#>show party name [party-name] hw-bypass
SCE#> hw-bypass for party "[party-name]" is
How to Display the Startup Configuration Party Database
From the SCE(config)#> prompt, type:
Command
show startup-config-party-db
The configuration file contents will be displayed only if the corresponding startup configuration party
Note
database is copied from the running configuration party database.
The following example shows how to display the contents of the startup party database:
SCE>enable 15
Password:<cisco>
SCE#>show startup-config-party-db
#This is a party database configuration file (running-config-party-db) for static parties
only.
#Created on 13:34:02
#cli-type 1
#version 1
hw-bypass mode
party name "N/A"
party name "[party-name]"
party mapping ip-address 24.11.52.128 name [party-name]
party mapping ip-address 110.10.10.10 name [party-name]
party name
SCE#>
OL-30621-02
UTC TUE July
[party-name] hw-bypass
Purpose
Displays the hardware bypass status of a specified
static party in the hardware bypass mode of the
Cisco SCE platform.
disabled
Purpose
Displays the contents of the startup configuration
party database of the static parties that are
configured in the Cisco SCE platform.
12 2011
Cisco SCE 8000 10GBE Software Configuration Guide
Hardware Bypass
8-11