Management Interface and Security
Management Interface and Security
The Cisco SCE 8000 platform is equipped with two RJ-45 management ports (Port1 and Port2 on the
Cisco SCE 8000-SCM-E module in slot 1). These ports provide access from a remote management
console to the Cisco SCE platform via a LAN.
The two management ports support management interface redundancy, providing the possibility for a
backup management link.
Note
The second management port is reflected in all objects related to it in the SNMP interface.
Cisco SCE 8000 does not support IPv6 addresses or connectivity on the management interfaces.
Note
Perform the following tasks to configure the management interface and management interface security:
•
•
Cisco SCE 8000 10GBE Software Configuration Guide
5-2
Configure the management port:
Physical parameters
–
Specify active port (if not redundant installation)
–
Redundancy (if redundant installation)
–
Configure management interface security
Configure the permitted and not-permitted IP addresses
–
Chapter 5
Configuring the Management Interface and Security
OL-30621-02