Mounting The Csacs 1120 Series Appliance In A 4-Post Rack; 4-Post Rack-Mount Hardware Kit - Cisco 1120 Installation Manual

Chapter 3 Installing and Configuring the Cisco 1120 Secure Access Control Server 4.2

Mounting the CSACS 1120 Series Appliance in a 4-Post Rack

When the appliance is installed in a rack and is fully extended on its slide rail, it is possible for the
Warning
rack to become unstable and tip over, which could cause serious injury. To eliminate the risk of rack
instability from extending the rail or in the event of an earthquake, you should affix the rack to
the floor.
This section contains:
•
•
•
•

4-Post Rack-Mount Hardware Kit

Figure 3-1
in a 4-post rack.
Figure 3-1
The following table describes the callouts in
1
Table 3-1
Table 3-1
Item
Slide rails
Multi-pin adapters
Fastener screws
Depending on the type of holes that your rack has, you will use different hardware to attach the appliance
to the rack:
•
OL-19455-01
4-Post Rack-Mount Hardware Kit
Installing the Slide Rails into a Rack with Square Holes
Installing the Slide Rails into a Rack with Round Holes
Installing the Appliance into the Slide Rails
shows the rails and release levers that you need to install the CSACS 1120 Series appliance
Release Levers on the Slide Rail Hardware
1
Slide release lever
lists the contents of the rack-mount hardware kit (Cisco part number CSACS-1U-RAILS).
Rack-Mount Hardware Kit
For racks with square holes, you use the multi-pin adapters to attach the appliance to the rack. The
installation kit includes four fastener screws that secure the multi-pin adapters after you install them
in the rack. Table 3-1 lists the contents of the installation kit.
Mounting the CSACS 1120 Series Appliance in a 4-Post Rack
2
Figure 3-1.
2 Component release lever
Quantity
2
4
4
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
3-3