Configuring The Fail-Over Mode - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 5 Configuring the Management Interface and Security
Configure the IP address for the management interface.
Step 3
The same IP address will always be assigned to the active management port, regardless of which physical
port is currently active.
See
Configure the speed and duplex for both management ports.
Step 4
See

Configuring the Fail-Over Mode

•
•
•
Use the following command to enable automatic failover. The automatic mode must be enabled to
support management interface redundancy. This mode automatically switches to the backup
management link when a failure is detected in the currently active management link.
This parameter can be configured when in management interface configuration mode for either
management port, and is applied to both ports with one command.
Options
The following options are available:
•
How to Enable the Automatic Fail-Over Mode
From the SCE(config if)# prompt, type:
Command
auto-fail-over
How to Disable the Automatic Fail-Over Mode
From the SCE(config if)# prompt, type:
Command
no auto-fail-over
OL-30621-02
Setting the IP Address and Subnet Mask of the Management Interface, page
Configuring the Management Interface Speed and Duplex Parameters, page
Options, page 5-9
How to Enable the Automatic Fail-Over Mode, page 5-9
How to Disable the Automatic Fail-Over Mode, page 5-9
auto/ no auto—Enable or disable automatic failover switching mode
Default—Auto (automatic mode)
–
Configuring the Management Ports
Purpose
Enables automatic failover mode.
Purpose
Disables automatic failover mode.
Cisco SCE 8000 10GBE Software Configuration Guide
5-4.
5-5.
5-9