Final Tests; How To Verify Operational Status; How To View The User Log Counters - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 3 Basic Cisco SCE 8000 Platform Operations
During the boot process, observe the following LEDs on the Cisco SCE 8000-SCM-E:
Step 4
•
•
•
It takes a several minutes for the Cisco SCE 8000 to boot and for the status LED to change from amber
Note
to green.

Final Tests

The procedures for performing the final tests to verify that the Cisco SCE 8000 is functioning properly
are explained in the following sections:
•
•

How to Verify Operational Status

After all the ports are connected, verify that the Cisco SCE 8000 is not in a Warning state.
On the front panel of the Service Control module, examine the Status LED; it should be green.
Step 1
To display the operation status of the system, at the Cisco SCE8000# prompt, type show system
Step 2
operation-status and press Enter.
A message displaying the operation status of the system appears. If the system is operating in order, the
following message appears:
System Operation status is Operational.
If the Status LED is red or flashing amber, the following message appears:
System Operation status is Warning
Description:
1. Power Supply problem
2. Line feed problem
3. Amount of External bypass devices detected is lower than expected amount

How to View the User Log Counters

View the user log for errors that occurred during the installation process.
At the SCE# prompt, type:
Command
show logger device user-file-log counters
OL-30621-02
The Power LEDs should be green.
Optical Bypass LED should be green while the Cisco SCE 8000 is in bypass and unlit when the
optical bypass is turned off.
The Status LED should be a constant amber while booting. After a successful boot, the Status LED
is steady green.
How to Verify Operational Status, page 3-3
How to View the User Log Counters, page 3-3
Starting the Cisco SCE 8000 Platform
Purpose
Shows the user log counters.
Cisco SCE 8000 10GBE Software Configuration Guide
3-3