Table of Contents
Advertisement
Configuring the Management Ports
The GBE management interface is configured as follows:
•
•
Enter configure and press Enter.
Step 1
Enters Global Configuration mode.
The command prompt changes to SCE(config)#.
Step 2
Enter interface mng (0/1 | 0/2) and press Enter.
Enters Management Interface Configuration mode.
The command prompt changes to SCE(config if)#
Configuring the Management Port Physical Parameters
This interface has a transmission rate of 10, 100, or 1000 Mbps and is used for management operations
and for transmitting RDRs, which are the output of traffic analysis and management operations.
•
•
•
Setting the IP Address and Subnet Mask of the Management Interface
You must define the IP address of the management interface.
When both management ports are connected, providing a redundant management port, this IP address
always acts as a virtual IP address for the currently active management port, regardless of which port is
the active port.
Options
The following options are available:
•
•
Cisco SCE 8000 10GBE Software Configuration Guide
5-4
mode: MNG Interface configuration mode
interface designation: 0/1 or 0/2
Setting the IP Address and Subnet Mask of the Management Interface, page 5-4
Configuring the Management Interface Speed and Duplex Parameters, page 5-5
Specifying the Active Management Port, page 5-7
IP address—The IP address of the management interface.
If both management ports are connected, so that a backup management link is available, this IP
address will be act as a virtual IP address for the currently active management port, regardless of
which physical port is currently active.
The following IP addresses are used internally by the Cisco SCE 8000 platform and cannot be
assigned to the management interface:
–
192.168.207.241 to 192.168.207.255
–
92.168.207.145 to 192.168.207.159
subnet mask—Subnet mask of the management interface.
Chapter 5
Configuring the Management Interface and Security
OL-30621-02
Advertisement
Chapters
Table of Contents
