Configuring The Management Ports; Entering The Management Interface Configuration Mode - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 5 Configuring the Management Interface and Security

Configuring the Management Ports

•
•
•
•
Perform the following tasks to configure the management ports:
•
•
•
Cable the desired management port, connecting it to the remote management console via the LAN. If
Step 1
connecting both management ports for redundancy, connect the to the LAN using a switch.
Configure the management port physical parameters. (See
Step 2
Parameters" section on page
(Optional) Configure the system with management interface redundancy. (see
Step 3
Redundancy" section on page

Entering the Management Interface Configuration Mode

When entering Management Interface Configuration Mode, you must indicate the number of the
management port to be configured:
•
•
The following Management Interface commands are applied only to the port specified when entering
Management Interface Configuration Mode. Therefore, each port must be configured separately:
•
•
The following Management Interface commands are applied to both management ports, regardless of
which port had been specified when entering Management Interface Configuration Mode. Therefore,
both ports are configured with one command:
•
•
OL-30621-02
Entering the Management Interface Configuration Mode, page 5-3
Configuring the Management Port Physical Parameters, page 5-4
Management Interface Redundancy, page 5-8
Monitoring the Management Interface, page 5-10
Configure the IP address and subnet mask (only one IP address for the management interface, not
one IP address per port).
Configure physical parameters:
Duplex
–
Speed
–
active port (optional)
–
Configure redundant management interface behavior (optional):
– Failover mode
5-4.)
0/1—Port1
0/2—Port2
speed
duplex
ip address
auto-failover
5-8.)
Cisco SCE 8000 10GBE Software Configuration Guide
Configuring the Management Ports
"Configuring the Management Port Physical
"Management Interface
5-3