Setting The Hold Time - Cisco SCE 8000 10GBE Software Configuration Manual

Configuring Cisco Discovery Protocol
Command
cdp enable
For consistent CDP operation, it is recommended that both ports of any one traffic link be either enabled
Tip
or disabled.

Setting the Hold Time

Use this command to set the mount of time the receiving device should hold a CDP packet from your
router before discarding it. Use either the no or the default form of the command to restore the holdtime
to the default value.
Options
The following option is available:
•
From the SCE(config)# prompt, type:
Command
cdp holdtime seconds
Setting the Timer
Use this command to configure how often the Cisco SCE 8000 platform sends CDP updates. Use either
the no or the default form of the command to restore the timer to the default value.
Options
The following option is available:
•
From the SCE(config)# prompt, type:
Command
cdp timer seconds
Cisco SCE 8000 10GBE Software Configuration Guide
6-24
seconds— Hold time value to be sent in the CDP update packets in seconds.
default = 180 seconds
seconds— How often the Cisco SCE 8000 platform sends CDP updates, in seconds.
default = 60 seconds
Chapter 6
Purpose
Enables CDP on a specific interface.
Purpose
Sets hold time.
Purpose
Sets the timer.
Global Configuration
OL-30621-02