Adding And Removing Servers - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 14 Value-Added Services (VAS) Traffic Forwarding

Adding and Removing Servers

Options
The following options are available:
•
•
How to Add a VAS Server to a Specified VAS Server Group
From the SCE(config if)# prompt, type:
Command
VAS-traffic-forwarding VAS server-group
group-number server-id id-number
How to Remove a VAS Server from a Specified VAS Server Group
From the SCE(config if)# prompt, type:
Command
no VAS-traffic-forwarding VAS server-group
group-number server-id id-number
How to Remove all VAS Servers from a Specified VAS Server Group
Use this command to remove all VAS servers from a specified VAS server group and set all group
parameters to the default value.
From the SCE(config if)# prompt, type:
Command
no VAS-traffic-forwarding VAS server-group
group-number
Configuring VAS Server Group Failure Parameters
You can configure these failure parameters for a specified VAS server group:
•
•
OL-30621-02
group-number—The ID number of the VAS server group
id-number—The ID number of the VAS server
Minimum number of active servers—If the number of active servers in the server group goes below
this number, the group will be in Failure state
Failure action—The action to be applied to all new flows mapped to this server group while it is
Failure state:
Block—all new flows assigned to the failed VAS server group will be blocked by the Cisco SCE
–
platform.
Pass—all new flows assigned to the failed VAS server group will be considered as regular
–
non-VAS flows, and will be processed without VAS service.
Configuring VAS Traffic Forwarding
Purpose
Adds a VAS server to a specified VAS server
group.
Purpose
Removes a VAS server from a specified VAS
server group.
Purpose
Removes all VAS servers from a specified VAS
server group.
Cisco SCE 8000 10GBE Software Configuration Guide
14-29