Displaying Hardware Health Status - Cisco TelePresence 7010 Help Manual

System status

Displaying hardware health status

The Health status page (Status > Health
the TelePresence Server.
Note: The Worst status seen conditions are those since the last time the TelePresence Server was
restarted.
To reset these values, click Clear. Refer to the table below for assistance in interpreting the information
displayed.
Table 6: Device health details
Field Field description
Fans Displays two possible states:
Voltages OK
n
Out of spec
RTC battery
n
States indicate both Current status and Worst
status seen conditions.
Temperature Displays three possible states:
OK
n
Out of spec
n
Critical
n
States indicate both Current status and Worst
status seen conditions.
Cisco TelePresence Server 7010 and MSE 8710 in Remotely Managed Mode Printable Help (4.0)
status) displays information about the hardware components of
Usage tips
The states indicate the following:
OK – component is functioning properly
n
Out of spec – Check with your support
n
provider; component might require service
If the Worst status seen column displays Out of
spec, but Current status is OK, monitor the
status regularly to verify that it was only a
temporary condition.
Note: Fans field does not display on 8710 as it
does not have fans.
The states indicate the following:
OK – temperature of the TelePresence
n
Server is within the appropriate range
Out of spec – Check the ambient
n
temperature (should be less than 34
degrees Celsius) and verify that the air vents
are not blocked
Critical – temperature of TelePresence
n
Server is too high. An error also appears in
the event log indicating that the system will
shutdown in 60 seconds if the condition
persists
If the Worst status seen column displays Out
of spec, but Current status is OK monitor the
status regularly to verify that it was only a
temporary condition.
Page 10 of 92