Table of Contents
Advertisement
Chapter 5
Configuring the Management Interface and Security
Enabling the SNMP Interface
Use this command to explicitly enable the SNMP interface.
The SNMP interface is implicitly enabled when any snmp-server command is executed to configure any
SNMP parameter. For more information on configuring and managing the SNMP parameters, including
hosts, communities, contact, location, and trap destination hosts, see
SNMP Interface" section on page
•
•
How to Enable the SNMP Interface
You must define at least one community string to allow SNMP access. For complete information on
community strings see
From the SCE(config)# prompt, type:
Command
snmp-server enable
How to Disable the SNMP Interface
From the SCE(config)# prompt, type:
Command
no snmp-server
Configuring SNMP Community Strings
•
•
•
To enable SNMP management, you must configure SNMP community strings to define the relationship
between the SNMP manager and the agent.
After receiving an SNMP request, the SNMP agent compares the community string in the request to the
community strings that are configured for the agent. The requests are valid under the following
circumstances:
•
•
OL-30621-02
How to Enable the SNMP Interface, page 5-45
How to Disable the SNMP Interface, page 5-45
"Configuring SNMP Community Strings" section on page
Defining a Community String, page 5-46
Removing a Community String, page 5-46
Displaying the Configured Community Strings, page 5-47
SNMP Get , Get-next , and Get-bulk requests are valid if the community string in the request matches
the read-only community.
SNMP Get , Get-next , Get-bulk and Set requests are valid if the community string in the request
matches the agent's read-write community.
5-41.
Purpose
Enables SNMP interface.
Purpose
Disables SNMP interface.
Cisco SCE 8000 10GBE Software Configuration Guide
Configuring and Managing the SNMP Interface
"Configuring and Managing the
5-45.
5-45
Advertisement
Chapters
Table of Contents
