Configuring The Global Default Timeout - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 5 Configuring the Management Interface and Security
To define a global default key, do the following:
From the SCE(config)# prompt, type:
Command
tacacs-server key key-string
To clear a global default key, do the following:
From the SCE(config)# prompt, type:
Command
no tacacs-server key

Configuring the Global Default Timeout

Use this command to define the global default timeout interval for the TACACS+ server hosts. This
default timeout interval can be overridden for a specific TACACS+ server host by explicitly configuring
a different timeout interval for that TACACS+ server host.
Options
The following options are available:
•
To define the global default timeout, do the following:
From the SCE(config)# prompt, type:
Command
tacacs-server timeout timeout-interval
OL-30621-02
timeout interval—Default time in seconds that the server waits for a reply from the server host
before timing out.
Default = 5 seconds
–
TACACS+ Authentication, Authorization, and Accounting
Purpose
Defines the global default key for the TACACS+
server hosts.
Purpose
No global default key is defined. Each TACACS+
server host may still have a specific key defined.
However, any server host that does not have a key
explicitly defined (uses the global default key) is
now configured to use no key.
Purpose
Defines global default timeout.
Cisco SCE 8000 10GBE Software Configuration Guide
5-21