How To Display Subscribers: By Mapping (Ip Address, Vpn, Or Vlan Id) - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 10 Managing Subscribers
From the SCE> prompt, type:
Command
show interface linecard 0 subscriber amount
property propertyname greater-than|less-than
property-val
How to display the number of subscribers that match a specified prefix
Options
The following options are available:
•
From the SCE> prompt, type:
Command
show interface linecard 0 subscriber amount
prefix prefix

How to Display Subscribers: By Mapping (IP Address, VPN, or VLAN ID)

•
•
•
•
•
•
You can display the subscribers who are mapped to any of the following:
•
•
•
•
•
You can also display just the number of subscribers with a specified mapping, rather than listing the
actual subscribers.
OL-30621-02
prefix—Subscriber prefix to match
How to display subscribers that are mapped to a specified IP address, or range of IP addresses,
page 10-26
How to display subscribers that are mapped to IP addresses that are included in a given IP address
or IP range, page 10-26
How to display subscribers that are mapped to a specified VLAN ID, page 10-26
How to display subscribers with no mapping, page 10-26
How to display the number of subscribers that are mapped to a specified VLAN ID, page 10-27
How to display the number of subscribers with no mapping, page 10-27
A specified IP address, or range of IP addresses
IP addresses intersecting a given IP address or IP range
A specified VLAN ID
A specified VPN
no mapping
Purpose
Displays the number of subscribers that are
greater than or less than a specified value of a
subscriber property.
Purpose
Displays the number of subscribers that match a
specified prefix.
Cisco SCE 8000 10GBE Software Configuration Guide
Monitoring Subscribers
10-25