Connecting The Test Equipment - Fluke 9132A Service Manual

9132A Service
Table 3-2.
EQUIPMENT TYPE
Mainframe
Interface Pod
Extender Board, 9100A-7651
Power Supply the §132A)
(for
Test Personality Module
Test
ROM, 28-pin*
Test *
ROM, 24-pin
Service Test *
Disk
Part
* the 9132A Service Test
of
Preparation for Troubleshooting the Pod
The 9132A to
the
Sync
Modules installed, and one or more
the number of installed
equal, the extra
partially
Begin
by
following
Set up
1.
and the monitor. Connect the 9000A-68000
with the Pod UUT cable
power
Place the 9132A to
back panel of
counterclockwise. Slide out the main
reaches the drawer
board shield
of the case.
Remove the main board shield
the main
3-12
Required Test Equipment
REQUIRED TYPE
Fluke 9100A (or 9105A)
Monitor (and Video Controller)
Software Version
least 3 megabytes
At
Fluke 9000A-68000
Fluke P/N 755637
Fluke 9100 Series or Fluke 9000 Series Mainframe
Power supply
*
Fluke P/N 822973
Fluke P/N 857482
Fluke P/N 818187
Fluke P/N 873943
Fluke P/N 859744.
Kit,
NOTE
be tested must have
Adapter cable, one or more Emulation
RAM
RAM
or
tested.
connecting the test equipment
describe this procedure:
steps
9105A) Mainframe, and connect the logic probe
the 9100A
(or
to
the Mainframe
and the
tested so the rear
be
Pod
the
by
press down on the center back of the main
stop,
release the safety detent,
to
PCA.
for Pod
Troubleshooting
Test System
Digital
or above
4.1
of RAM
or
and +12V regulated outputs
with +5V, -5V,
Module
the Sync
Modules.
ROM
and Modules
ROM
Module can
ROM only be
9132A being tested. The
to the
cable to
Pod
the Pod's self test socket. Tum
in
monitor.
panel is
thumbscrews on each
the
turning
When the main board
board.
pull the main board free
and
unsnapping the shield standoffs from
by
with:
3-18.
with
RAM
If
is not
Mainframe
the
the
on
accessible. Open the
side