Table of Contents
Advertisement
Remove the Main PCA from the panel
8.
away from the four press-fit standoffs (two near the front of the PCA
two near the middle).
and
Removing the Self Test
Use the following
Check that
1.
2.
Open the self test drawer on the right-hand side of the Pod. Once the
drawer reaches
the drawer and continue pulling on the drawer until it
case.
3.
Remove the flat
Remove the three screws holding
4.
(two near the self test cable connector
connector).
Remove the Self Test PCA from the drawer
5.
board away from the two press-fit standoffs (near the ZIF socket).
Removing the
ROM
Use the following steps to
Check that the ROM Module is disconnected from the UUT and that
1.
to
power
Turn the bottom of the module
2.
from the comers of the case.
unit.
Tum the module over and place the handle of the ZIF socket in its
3.
upward position.
4.
Carefully pull the
Removing the Sync Module
Use the following steps to
Check that
1.
to
power
Tum the bottom of the module
2.
from the corners of the
unit,
Remove the grommet holding the RESET line from the case. Carefully
3.
pull the
PCA
to
access
gain
steps
to
the Pod is OFF.
power
its
stop, push upward
test
cable from the connector
self
Module
PCA
access to the ROM Module PCA:
gain
the module
OFF.
is
Pull
of the case
top
PCA
access to the
gain
Module
the Sync
the module is
OFF.
case.
of the case away from
top
carefully pulling
by
the 9132A Self Test PCA:
to
the metal
tab
on
on the
Self Test PCA to
the
and
one near
carefully pulling
by
remove the four Phillips screws
up, and
the bottom away from the rest of the
from the ROM Module PCA.
away
Module PCA:
Sync
disconnected from the UUT
is
four Phillips screws
up, and
remove
the
the bottom away from
Pull
Sync Module PCA.
the
9132A Service
board
the
3-22.
on the bottom of
of the Pod
is free
Self Test
PCA.
drawer
the
Sync Module
the
the
3-23.
3-24.
that
and
rest of
the
the
3-17/18
Advertisement
Table of Contents
