Performance Tests; Required Test Equipment - Fluke 7526A Calibration Manual

7526A
Calibration Manual

Performance Tests

To prevent possible electrical shock, fire, or personal injury, do
not perform the performance test procedures unless the
Product is fully assembled.
The performance tests verify the complete operation of the Product and measure the
accuracy of each function against Product specifications. If the Product fails a part of the
test, calibration adjustment or repair is necessary. See "Calibration Adjustment".

Required Test Equipment

The equipment listed in Table 3 is necessary to do the performance tests and calibration
adjustment.
Equipment
8-1/2 digit Precision Digital
Multimeter (DMM)
Ohms shorting block
1 Ω Resistance Standard
Resistance standard, 10 Ω
Resistance standard, 100 Ω
1 KΩ Resistance Standard
10 KΩ Resistance Standard
Multifunction Calibrator
Thermistor probe
Thermocouple probe
Pressure Module
Lead Set
Precision Thermistor
Thermometer Readout
Dewar Flask with Lid
Characterized Type E
Thermocouple
Banana Jack to Copper TC Mini-
connector
Lag bath
12
Warning
Table 3. Required Equipment
Recommended Model
Fluke 8508A
Fluke 742A-1
Fluke 742A-10
Fluke 742A-100
Fluke 742A-1K
Fluke 742A-10K
Fluke 5522A
Fluke5640-D
Omega E-type thermocouple
probe
Any Fluke 700 Series Module
5520A-525A/LEADS Leads Kit
Fluke 5640-D
Fluke 1504
- - -
- - -
- - -
Where Used
DC volts, dc current, resistance
Low ohms measure and SPRT
calibration and high ohms
measure calibration
DC current
100 mA source calibration
Low ohms measure and SPRT
calibration
Resistance
Resistance
DC volts, dc current, resistance
TC CJC calibration
TC CJC calibration
Pressure
Necessary test cables
Temperature
Temperature
Thermocouple
Thermocouple
Thermocouple
TC CJC calibration