Table of Contents
Advertisement
9132A Service
The tests prompt you for information on the Pod configuration whenever
necessary, or for operator
failure
is
press ENTER/YES.
Whenever a failure is located, the Service Test stops
message on the Mainframe display. The error message indicates the type of
failure that has occurred
failure can most likely be
Service Test program should be run again
found.
The following paragraphs describe each part of the Service Test and the
functional tests that are associated
Main Board Full Functional Test
1.
The Main Board Full functional test menu selection runs the full
functional
Main Board Full
+»
0
4
es
eo
4
0
0
0
6
+
4
0
©
3-14
Service
Figure 3-8.
steps.
found.
To return
to
the general area
and
found.
The following sub-functional tests are run during the
test.
test:
function
Bus Test
Kemel ROM
Kernel RAM
Emulation RAM
Personality Module
State Machine
Sync Module
Bank Swap Circuit
Address Comparator
ROM Module
RUN UUT Circuit
Address RAM
Clock Fail Circuit
Cal Test Point
Mainframe Port
ROM Module 2,
3, and
Test
Program
Menu
The Service Test stops whenever the first
the main menu after the test has stopped,
which the cause of the
in
Once the failure has
if
any other failure can be
to see
with them:
4
shows
and
error
an
corrected, the
been
sub-
Advertisement
Table of Contents
