Upgrading G450 Firmware Using The Cli Via A Usb Device; Cli Commands For Upgrading G450 Firmware Via A Usb Device; Example Upgrade Using The Cli Via A Usb Device - Avaya G450 Installing And Upgrading

Upgrading G450 firmware using the CLI via a USB device

You can upgrade firmware via a USB mass storage device using the CLI. The upgrade files
must first be downloaded to a local PC.
1. Prepare installation worksheets. See
2. Download the firmware files to a PC. See
PC on page 112.
3. Insert a USB mass storage device into the PC's USB port, and copy the firmware files to
the USB mass storage device.
4. Remove the USB mass storage device from the PC, and insert it into a G450 USB port.
5. Run CLI commands to copy the firmware files from the USB mass storage device to the
G450. See

CLI Commands for upgrading G450 firmware via a USB device

You can use CLI commands to upload an upgrade file from a USB mass storage device to the
G450. You must use the specific path to the file on the USB mass storage device.
Use the copy usb EW_archive command to upgrade the Java applet for Avaya G450
●
Manager software from a USB mass storage device
Use the copy usb module command, followed by the slot number of the module you
●
want to upgrade, to upgrade the firmware on a media module from a USB mass storage
device
Use the copy usb SW_imageA command to upgrade the G450 firmware into Bank A
●
from a USB mass storage device
Use the copy usb SW_imageB command to upgrade the G450 firmware into Bank B
●
from a USB mass storage device

Example upgrade using the CLI via a USB device

To upgrade the firmware of an MM712 media module in slot 3 from a USB mass storage device
where the upgrade file is located in the directory \temp\, use the following command:
copy usb module usb-device0 \temp\mm712v51.fdl 3
CLI Commands for upgrading G450 firmware via a USB device
Upgrading G450 firmware using the CLI via a USB device
Preparing installation worksheets
Downloading G450 firmware files to a local
on page 105.
on page 111.
Issue 2 June 2008 111