High Voltage Charging Operation; Sae J1772 Charging Inlet; Ac Level 1 Charging (120 Volt, 12 Amp) - Chrysler PACIFICA HYBRID 2023 Manual

8 GETTING TO KNOW YOUR VEHICLE
NOTE:
 When the "Please Leave Key In RUN — Battery Condi-
tioning Needed" message is displayed, keep the igni-
tion in the RUN position for the battery to recover. Place
the ignition back in the OFF position when the message
disappears, and then start the vehicle. When this
message is displayed, do not operate any air condi-
tioning controls.
 Under these high or low temperatures, if the vehicle is
plugged in, and the ignition is in the OFF position, the
vehicle may "wake up" to precondition the high voltage
battery for use.
 It is recommended that the vehicle be plugged in over-
night when possible to maximize the electric range of
the vehicle.
The messages will only be displayed when the ignition is in
the ON/RUN position and the high voltage battery is not
ready to provide propulsion power. The message also
displays if there is a failed attempt to achieve READY state
when the high voltage battery cell temperatures are either
too cold or too hot.

HIGH VOLTAGE CHARGING OPERATION

SAE J1772 C I
HARGING NLET
Your vehicle uses an industry standard SAE J1772 charge
inlet (vehicle charge inlet) for both AC Level 1 (120 V) and
AC Level 2 (240 V) charging.
Vehicle Charge Inlet
Open the charge port door by pushing near the rear outer
edge of the door, near the center to unlatch. To close the
charge port door, engage the door latch by pushing on the
rear outer edge near the center.
AC L 1 C
EVEL HARGING
(120 V , 12 A )
OLT MP
Your vehicle is equipped with a 120 Volt AC, SAE J1772
Level 1 Electric Vehicle Supply Equipment (EVSE), also
referred to as a Portable Charging Cordset (EVSE). AC
Level 1 charging requires a conventional NEMA 5-15R
120 Volt AC grounded wall outlet along with the Portable
Charging Cordset (EVSE) provided with the vehicle.
WARNING!
Please be sure to follow these warnings. Failure to do
so may result in serious injury or death.
 Discontinue use of the Portable Charging Cordset
(EVSE) immediately if the plug or outlet becomes hot
to the touch or if you notice any unusual odors.
 Do not use the Portable Charging Cordset (EVSE) in
building structures that use fuse-based circuit
protection. Use only with electrical circuits protected
by circuit breakers.
 Do not use the Portable Charging Cordset (EVSE) if
other devices are plugged into the same circuit.
 When unplugging the Portable Charging Cordset
(EVSE) from the wall outlet, be sure to pull by the
plug, and not the cord.
 Do not pull, twist, bend, step on or drag the cord of
the Portable Charging Cordset (EVSE).
 Stop using the Portable Charging Cordset (EVSE)
immediately if charging stops before it's completed
when the plug or cord is moved or adjusted.
(Continued)