Nortel 1000E PRI Installation And Commissioning Manual page 95

Prompt Response
- SREF Card
... ...
0 - 15
TRSH
RALM 1–(3)–128
... ...
Use
LD 73" (page 95)
timers.
Procedure 24
Configuring PRI2 data block for system timers using LD 73
Step
1
2
3
Table 25
Configuration for PRI2 data block system timers (LD 73)
Prompt Response
aaa
REQ
TYPE PRI2
FEAT SYTI
... ...
MGCLK sl s c
- PREF Card
Media Gateway 1000E PRI Gateway Installation and Commissioning
Description
Card number of PRI containing the Secondary Clock
Reference for the second IPMG.
To modify, use the CHG command (you can change the
PREF only if you change the MGCLK).
Create or change a PRI threshold set.
Enter this number in LD 17 when defining the PRI loop.
Yellow alarm (remote alarm) 24-hour threshold.
Number of remote alarm clear signals received in 24 hours.
Procedure 24 "Configuring PRI2 data block for system timers using
to configure the 2 Mb/s PRI2 data block including system
Action
Log on to the CS 1000E.
To access LD 73, enter:
LD 73
Enter the responses shown in
data block system timers (LD 73)" (page
Description
Request (aaa = CHG, END, NEW, OUT, or PRT).
DTI2 and JDMI are not supported for MGP.
Feature = SYTI (System Timers)
Superloop, shelf, card number of PRI2 containing the
Primary Clock Reference for the first IPMG.
The card number (1 - 8) should match the span number
configured through the Web interface.
Card number of PRI2 containing the Primary Clock
Reference for the first IPMG.
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Configure E1/T1 ports on a Call Server 95
--End--
Table 25 "Configuration for PRI2
95).