Table of Contents
Advertisement
Figure 25
Modem connection
Telnet
You can use the CLI to access Telnet as follows:
•
For the logon, enter:
mgp
•
For the password, enter:
admin
Upon access to the CLI, you must log on through the administrative or
debug level. See
FTP
You can access the E1/T1 card remotely by FTP for the file transfer. The
FTP logon and password are the same as those defined for Telnet. After
you log on, standard FTP commands apply.
Initial configuration of an E1/T1 card through the command line
interface
Follow the steps in
by CLI" (page
configuration, administration and maintenance through the Web-based
interface.
Procedure 40
Configuring basic LAN parameters by CLI
Step
Action
1
Connect the RS-232 serial port (D-type 9 pins) to a terminal or a
PC with terminal emulation (for example, HyperTerminal).
2
Configure the interface to:
Media Gateway 1000E PRI Gateway Installation and Commissioning
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
"CLI commands" (page
Procedure 40 "Configuring basic LAN parameters
113). After the initial configuration, you carry out all
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Initial configuration of the E1/T1 card 113
151).
Advertisement
Table of Contents
