Table of Contents
Advertisement
.
Introduction
This chapter contains information about the following topics:
•
"Overview" (page 21)
•
"Applicable systems" (page 22)
•
"Intended audience" (page 22)
•
"Conventions" (page 23)
•
"Related information" (page 23)
Overview
This document is a global document. Contact your system supplier or your
Nortel representative to verify that the hardware and software described
are supported in your area.
This document provides the information necessary to install and configure
a Media Gateway 1000E PRI (Peripheral Rate Interface) Gateway (MG
1000E PRI Gateway).
The MG 1000E PRI Gateway is a digital trunk gateway that supports up
to eight E1/T1 spans.
ATTENTION
At this time DTI and JDMI are not supported on the MG1000E PRI Gateway
(MGP). Only E1 & T1 PRI protocols are supported on this gateway.
The MG 1000E PRI Gateway can contain the following new components:
•
an E1/T1 card (NTDW70AA) that provides a base of four spans and
allows an additional four spans with an expansion daughterboard
(NTDW75AA) for a total of a possible eight spans
•
a 2u Gateway chassis (NTDW72) that provides a power supply,
backplane, and fan
•
a DB-128 DSP Daughterboard (NTDW78) is available for the MGC
card.
Media Gateway 1000E PRI Gateway Installation and Commissioning
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
21
Advertisement
Table of Contents
