Table of Contents
Advertisement
104 Configure an E1/T1 card
Prompt
Response
DES
DPNSS
...
...
DDSL
0 - 15
SIGL
DPN/DAS
xx
CUST
NCOS
(0) - 99
...
...
RTMB
0-511 1-4000
...
...
TGAR
0 - (1) - 31
...
...
aaaa
CLS
...
...
Enable PRI spans
For every span on the E1/T1 card, enable the NTBK51AA/NTBK51CA card
or the NTAK93AB daughterboard and enable the clock controller.
If you use the NTBK51AA/NTBK51CA daughterboard, follow the procedure
described in
daughterboard" (page 104)
If you use the NTAK93AB daughterboard, follow the procedure described
in
Procedure 34 "Enabling the NTAK93AB daughterboard" (page 105)
enable the DPNSS/DASS spans through software.
To enable the clock controller, follow the procedure described in
35 "Enabling the clock controller" (page
Procedure 33
Enabling the NTBK51AA/NTBK51CA daughterboard
Media Gateway 1000E PRI Gateway Installation and Commissioning
Description
Designator field for trunk.
DASS2/DPNSS D-channel logical port number, entered in
LD 74.
DPN = DPNSS signaling
DAS = DASS signaling
Customer number, as defined in LD 15.
Network Class of Service group.
Route number and member number.
Range is the same as that for CS 1000E system.
Trunk Group Access Restriction. The default "1"
automatically blocks direct access.
Class of Service.
Procedure 33 "Enabling the NTBK51AA/NTBK51CA
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
--End--
to enable the PRI spans through software.
105).
to
Procedure
Advertisement
Table of Contents
