Table of Contents
Advertisement
3
Mount the D-channel daughterboards on the E1/T1 card.
4
Insert the E1/T1 card in the dedicated lower slot of the PRI
Gateway chassis. If the DCH daughterboard is installed, the
DCH LED flashes three times.
5
Connect the E1/T1 cables (RS-232, Ethernet, and RJ-45 E1/T1
connectors).
6
Connect the power cable.
7
Turn on the power.
Connect the RS-232 cable
This connection is used for the initial setup of basic LAN parameters by
CLI. After initial setup, all configuration, administration and maintenance
are done through the Web interface. See
RS-232 cable" (page
Procedure 8
Connecting the RS-232 cable
Step
Action
1
Connect the RS-232 serial port (D-type 9 pins) to a terminal or a
PC with terminal emulation (for example, HyperTerminal).
ATTENTION
To connect the RS-232 cable, you require a null modem adapter.
2
Configure the RS-232 serial port interface as follows:
•
•
•
•
•
Media Gateway 1000E PRI Gateway Installation and Commissioning
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
61).
9600 baud
8 data bits
1 stop bit
No parity
Flow control is "none"
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Install an E1/T1 card 61
--End--
Procedure 8 "Connecting the
--End--
Advertisement
Table of Contents
