Table of Contents
Advertisement
Step
Action
1
In LD 60, enter the command to enable all 1.5/2.0 Mb PRI loops
through the software:
ENLL L
2
If the DDCH is disabled, enter the command in LD 96 to enable
the DDCH:
ENL MSDL sl s c
3
To enable the D-channels, enter the command in LD 96:
ENL DCH X
4
To request the current status of the D-channel, enter the
command:
STAT DCH
If the D-channel is established and operational, the system
responds with DCH x EST in LD 96.
Procedure 34
Enabling the NTAK93AB daughterboard
Step
Action
1
In LD 75, enter the command to enable all PRI loops:
ENL DDCS 1
2
Enter the command to enable the DCHI where the DCHI is
enabled, but all channels are disabled:
ENL DDSL n
3
To enable the D-Channels, enter this command:
STRT n
4
To request the current status of the D-channel, enter the
command:
STAT DDSL
If the D-channel is operational and enabled, the response is
ENBL ACTIVE. All configured channels are normally enabled.
Procedure 35
Enabling the clock controller
Nortel Communication Server 1000
Media Gateway 1000E PRI Gateway Installation and Commissioning
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Enable PRI spans
--End--
--End--
105
Advertisement
Table of Contents
