Nortel 1000E PRI Installation And Commissioning Manual page 86

86 Configure an E1/T1 card
Prompt Response
YALM FDL, DG2
0 - 15
TRSH
... ...
Procedure 17 "Configuring PRI2 loops using LD 17" (page 86)
the configuration in LD 17 to support PRI2/E1 loops (common equipment
parameters) on the PRI Gateway.
Procedure 17
Configuring PRI2 loops using LD 17
Step
1
2
3
Table 17
PRI2 loop configuration (LD 17)
Prompt Response
REQ CHG
TYPE CEQU
CFN YES
...
PRI2 loop
MG_CARD supl sh card
Procedure 18 "Configuring DPNSS/DASS loops using LD 17" (page
87) shows the configuration in LD 17 needed to support DPNSS loops
(common equipment parameters) on the PRI Gateway.
Media Gateway 1000E PRI Gateway Installation and Commissioning
Description
Yellow alarm method.
Threshold.
Action
Log on to the CS 1000E.
To access LD 17, enter:
LD 17
Enter the responses shown in
(LD 17)" (page 86).
Description
Change existing data.
Make changes to common equipment parameters.
Common equipment.
Digital loop (2.0 Mb) (0 - 254)
The physical card for the PRI2 loop association to the
PRI Gateway.
The format is superloop, shelf, card.
For the PRI Gateway, card 1 to 8 is applicable.
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
--End--
Table 17 "PRI2 loop configuration
--End--
describes