Inspect The Tires, Wheels And Lug Nut Torque - Genie S-40 Service Manual

October 2013
a b
a oil cooler
b cylinder head cooling fins
c fan blower fins
Cooling and fan blower fins
5 Inspect the fan blower fins for physical damage.
6 Clean the fan blower fins of debris and foreign
material.
7 Inspect the head cooling passages and fins for
physical damage or foreign material, using a
flashlight.
8 Clean the cylinder head cooling passages of
debris and foreign material.
9 Install the engine side cover.
10 Swing the engine back to its original position
and install the engine pivot plate retaining
fasteners. Tighten the pivot fastener.
Crushing hazard. Failure to install
the fasteners into the engine tray
to secure it from moving could
result in death or serious injury.
Part No. 102521
c
S-40 • S-45
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
B-8
Inspect the Tires, Wheels
and Lug Nut Torque
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Maintaining the tires and wheels in good
condition including proper wheel fastener torque is
essential to safe operation and good performance.
Tire and/or wheel failure could result in a machine
tip-over. Component damage may also result if
problems are not discovered and repaired in a
timely fashion.
Bodily injury hazard. An over-
inflated tire can explode and could
cause death or serious injury.
Tip-over hazard. Do not use
temporary flat tire repair products.
Note: The tires on some machines are foam-filled
and do not need air added to them.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracks.
3 Check each lug nut for proper torque. Refer to
Section 2, Specifications .
Models with air-filled tires:
4 Check pressure in each air-filled tire. Add air as
necessary. Refer to Section 2, Specifications .
3 - 21