Replace The Drive Hub Oil - Genie S-40 Service Manual

October 2013
Ford models
Required maintenance procedures and additional
engine information are available in the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302) or the
Ford DSG-423 EFI Operator Handbook
(EDI part number 1060020) or the
Ford MSG-425 EFI Operator Handbook
(Ford part number 1020010).
Ford LRG 425 EFI Operation Manual
Genie part number
Ford DSG 423 EFI Operator Handbook
Genie part number
Ford MSG-425 EFI Operator Handbook
Genie part number
To access the engine:
Remove the engine tray retaining fasteners
located under the engine tray. Loosen the pivot
fastener located at the platform end of the
engine tray. Swing the engine tray out and
away from the machine and secure it from
moving.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
Part No. 102521
Section 3 • Scheduled Maintenance Procedures
A-8

Replace the Drive Hub Oil

Manufacturer drive hub specifications require that
this one-time procedure be performed after the first
150 hours.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the torque hub oil after the first 50 hours of
84792
use may cause the machine to perform poorly and
continued use may cause component damage.
119488
1 Select the drive hub to be serviced. Drive the
machine until one of the two plugs is at the
lowest point.
215322
2 Remove both plugs and drain the oil into a
suitable container.
3 Drive the machine until one plug is at the top
and the other is at 90 degrees.
4 Fill the hub with oil from the top hole until the oil
level is even with the bottom of the side hole.
Refer to Section 2, Specifications.
5 Install the plugs. Use pipe thread sealant on
units with pipe plugs.
6 Repeat steps 1 through 5 for all the other drive
hubs.
models with pipe plugs
S-40 • S-45
CHECKLIST A PROCEDURES
a drive hub plugs
a
3 - 11