Trane TR150 Programming Manual page 77

Parameters
14-53 Fan Monitor
Select which reaction the frequency converter should take in
case a fan fault is detected. This parameter is only valid for
frequency converters of the following enclosure sizes:
•
IP20, 3x200–240 V, enclosure sizes H6–H8.
3 3
•
IP20, 3x380–480 V, enclosure sizes H6–H8.
•
IP54, 3x380–480 V, enclosure sizes I6–I8.
•
IP20, 3x525–600 V, enclosure sizes H6–H10.
Option:
[0]
[1]
*
[2]
14-55 Output Filter
Select whether an output filter is present.
Option:
[0] No Filter
*
[1] Sine-Wave Filter
[3] Sine-Wave Filter
with Feedback
[4] dv/dt
3.10.7 14-6* Auto Derate
Parameter group for configuring automatic derating based
on the output frequency of the frequency converter.
14-63 Min Switch Frequency
Set the minimum switching frequency allowed by the output
filter.
Option:
[2]
*
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
76
TR150 and TR170
Function:
Disabled
Warning
Trip
Function:
This option in only valid for the
frequency converter of the following
enclosure sizes:
•
IP20, 3x200-240 V, enclosure
sizes H6-H8
•
IP20, 3x380-480 V, enclosure
sizes H6-H8
•
IP54, 3x380-480 V, enclosure
sizes I6-I8
•
IP20, 3x525-600 V, enclosure
sizes H6-H10
Function:
2.0 kHz
3.0 kHz
4.0 kHz
5.0 kHz
6.0 kHz
8.0 kHz
10.0 kHz
12.0 kHz
16.0 kHz
02/2017 All rights reserved.
14-64 Dead Time Compensation Zero Current Level
If a long motor cable is used, set the parameter to [0] Disabled to
minimize the motor-torque ripple.
Option:
[0] Disabled
*
[1] Enabled
14-65 Speed Derate Dead Time Compensation
Range: Function:
Size [ 20 - Dead time compensation level is reduced
related 1000 Hz] linearly from the maximum level of the
*
output frequency set in
parameter 14-07 Dead Time Compensation
Level to the minimum level of the output
frequency set in this parameter.
3.10.8 14-9* Fault Settings
The parameter group for fault customization settings.
14-90 Fault Level
Use this parameter to customize fault levels. Only index 7, which
indicates overcurrent faults, is supported.
Option: Function:
[3] Trip lock Alarm is set to trip lock level.
*
[4] Trip w. Alarm is configured into trip alarm, which
delayed reset can be reset after a delay time. For
example, if overcurrent alarm is configured
to this option, it can be reset 3 minutes
after the alarm is reported.
[5] Flystart The frequency converter tries to catch a
motor spinning when starting. If this option
is selected, parameter 1-73 Flying Start s set
to [1] Enabled.
Function:
BAS-SVP16B-EN