Introduction; Purpose Of The Manual; Document And Software Version; Safety Symbols - Trane TR150 Programming Manual

Introduction

1 Introduction

1.1 Purpose of the Manual

This programming guide provides information for
advanced programming of the frequency converter. It
provides a complete overview of all parameters and
descriptions for all parameters.
The programming guide is intended for use by qualified
personnel.
To operate the frequency converter safely and profes-
sionally, read and follow the programming guide, and pay
particular attention to the safety instructions and general
warnings.

1.2 Document and Software Version

This manual is regularly reviewed and updated. All
suggestions for improvement are welcome.
Edition Remarks
BAS-SVP16B-EN Update to new
software version and
addition of TR170.
Table 1.1 Document and Software Version

1.3 Safety Symbols

The following symbols are used in this guide:
WARNING
Indicates a potentially hazardous situation that could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation that could
result in minor or moderate injury. It can also be used to
alert against unsafe practices.
NOTICE
Indicates important information, including situations that
can result in damage to equipment or property.
BAS-SVP16B-EN
Programming Guide

1.4 Safety Precautions

WARNING
HIGH VOLTAGE
Frequency converters contain high voltage when
connected to AC mains input, DC supply, or load sharing.
Failure to perform installation, start-up, and maintenance
by qualified personnel can result in death or serious
injury.
•
WARNING
UNINTENDED START
When the frequency converter is connected to AC mains,
DC supply, or load sharing, the motor can start at any
time. Unintended start during programming, service, or
repair work can result in death, serious injury, or
Software version
property damage. The motor can start with an external
2.9x
switch, a fieldbus command, an input reference signal
from the LCP or LOP, via remote operation using Trane
Drive Utility (TDU), or after a cleared fault condition.
To prevent unintended motor start:
•
•
•
02/2017 All rights reserved.
Only qualified personnel must perform instal-
lation, start-up, and maintenance.
Press [Off/Reset] on the LCP before
programming parameters.
Disconnect the frequency converter from the
mains.
Completely wire and assemble the frequency
converter, motor, and any driven equipment
before connecting the frequency converter to
AC mains, DC supply, or load sharing.
1 1
3