Connecting To The Telephone Line - Olivetti OFX 2200 Instructions Manual

In some countries the installation procedure is performed by the customer engineering service. To
install the machine yourself, follow the procedure described below.
WARNING: Check that the power cable is unplugged before connecting the machine to the
telephone line.
To connect the facsimile machine and a telephone or answering machine to the telephone line,
proceed as follows:
1. Connect one end of the telephone line connection cable to the line socket (LINE) on the
facsimile machine, and the other end to the wall telephone socket (see "case 1" or "case 2"
figure). Note: if the network to which the facsimile machine is connected has more than one
socket connected in series, the facsimile machine must be connected to the primary socket.
2. Make the telephone/answering machine connection (if available) in either of the following
ways:
a) if the telephone line connection cable provided with the facsimile machine has an extension
plug (with socket): plug the telephone/answering machine cord into the extension plug (with
socket), (see "case 1" figure).
b) if the telephone line connection cable provided with the facsimile machine does not have
an extension plug (with socket): connect the telephone/answering machine cord's "minia-
ture" connector directly to the connection socket (TEL1 or TEL2) on the facsimile machine,
removing the plastic cap, if fitted (see "case 2" figure).
E. g.: connecting the facsimile machine and the telephone to the telephone line (case 1)

CONNECTING TO THE TELEPHONE LINE

to LINE socket
TEL2 TEL1 LINE
5