Snmp-Server Community - Planet Networking & Communication WGSW-48040HP Command Manual

any any security model
v1 v1 security model
v2c v2c security model
v3 v3 security model
level security level
auth authNoPriv Security Level
noauth noAuthNoPriv Security Level
priv authPriv Security Level
read specify a read view for the group
<ViewName : word255>
write specify a write view for the group
<WriteName : word255>
Default:
None
Usage Guide:
To configure the Access of SNMP
Example:
To configure the Access (below table) of SNMP
Switch# configure terminal
Switch (config)# snmp-server access default_rw_group model v2c level priv read
default_view write default_view

4.2.159 snmp-server community

Command:
snmp-server community { v2c <comm> [ ro | rw ] | v3 <v3_comm> [ <v_ipv4_addr>
<v_ipv4_netmask> ] }
snmp-server Set SNMP server's configurations
community Set the SNMP community
v2c SNMPv2c
<comm> Community word
ro Read only
rw Read write
v3 SNMPv3
<V3Comm : word127>
read view name
write view name
Community word
Command Guide of WGSW-48040HP
-252-