Snmp-Server Community - Planet Networking & Communication MGSW-28240F Command Manual

<ViewName : word255>
write specify a write view for the group
<WriteName : word255>
Default:
None
Usage Guide:
To configure the Access of SNMP
Example:
To configure the Access (below table) of SNMP
Switch# configure terminal
Switch (config)# snmp-server access default_rw_group model v2c level priv read
default_view write default_view

4.2.194 snmp-server community

Command:
snmp-server community { v2c <comm> [ ro | rw ] | v3 <v3_comm> [ <v_ipv4_addr>
<v_ipv4_netmask> ] }
snmp-server Set SNMP server's configurations
community Set the SNMP community
v2c SNMPv2c
<comm> Community word
ro Read only
rw Read write
v3 SNMPv3
<V3Comm : word127>
<ipv4_addr> IPv4 address
<ipv4_netmask>
Default:
None
Usage Guide:
read view name
write view name
Community word
IPv4 netmask
Command Guide of MGSW-28240F
-291-