Tacacs-Server Deadtime; Tacacs-Server Host - Planet Networking & Communication WGSW-48040HP Command Manual

4.2.165 tacacs-server deadtime

Command:
tacacs-server deadtime <minutes>
tacacs-server Configure TACACS+
deadtime Time to stop using a TACACS+ server that doesn't respond
<Minutes : 1-1440>
Default:
0
Usage Guide:
To configure the Deadtime of TACACS+ Server
Example:
To enable the Deadtime (6) of TACACS+ Server
Switch# configure terminal
Switch (config)# tacacs-server deadtime 6

4.2.166 tacacs-server host

Command:
tacacs-server host <host_name> [ port <port> ] [ timeout <seconds> ] [ key <key> ]
tacacs-server Configure TACACS+
host Specify a TACACS+ server
<HostName : word1-255>
key Server specific key (overrides default)
port TCP port for TACACS+ server
<Port : 0-65535>
timeout Time to wait for this TACACS+ server to reply (overrides default)
<Seconds : 1-1000>
<Key : line1-63>
Default:
None
Usage Guide:
To configure the Host of TACACS+ Server
Example:
To enable the Host (below table) of TACACS+ Server
Time in minutes
Hostname or IP address
TCP port number
Wait time in seconds
The shared key
Command Guide of WGSW-48040HP
-268-