Lldp Tlv-Select Management-Address; Lldp Tlv-Select Port-Description - Planet Networking & Communication WGSW-48040HP Command Manual

lldp LLDP configurations
receive Enable/Disable decoding of received LLDP frames.
Default:
Both (Tx +Rx)
Usage Guide:
To configure LLDP Rx only mode for specific interface
Example:
To configure LLDP Rx only mode for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp receive

4.2.45.49 lldp tlv-select management-address

Command:
lldp tlv-select management-address
lldp LLDP configurations
tlv-select To transmit which optional TLVs.
management-address
Default:
Enabled
Usage Guide:
To enable management address of LLDP TLV for specific interface
Example:
To enable management address of LLDP TLV for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp tlv-select management-address

4.2.45.50 lldp tlv-select port-description

Command:
Enable/Disable transmission of management address.
Command Guide of WGSW-48040HP
-94-