Access-List Shutdown; Aggregation Group - Planet Networking & Communication WGSW-48040HP Command Manual

Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # access-list redirect interface GigabitEthernet 1/2

4.2.45.8 access-list shutdown

Command:
access-list shutdown
shutdown Shut down incoming port. The shutdown feature only works when the packet length is less than 1518
(without VLAN tags).
Default:
Disable
Usage Guide:
To enable Shutdown function for the ACL.
Example:
To enable ACL Shutdown function for the GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # access-list shutdown

4.2.45.9 aggregation group

Command:
aggregation group <uint>
aggregation
group Create an aggregation group
<uint> The aggregation group id
Default:
N/A
Usage Guide:
To configure aggregation group.
Example:
To configure aggregation group 7 for the GigabitEthernet X/X.
Create an aggregation
Command Guide of WGSW-48040HP
-73-