Genie GS-2669 DC Service And Repair Manual page 89

Service and Repair Manual
Steer Axle Components
17 Install the steer sensor actuator onto the tie
rod pivot pin.
18 Insert the compression spring into the steer
sensor and push the tie rod pivot pin up until
the actuator hex pin is engaged into the steer
sensor.
Note: Be sure the sensor actuator hex pin is
engaged into the sensor.
19 Rotate the tie rod pivot pin counterclockwise
approximately 90° and secure it to the tie rod.
20 Install the steer sensor cover.
21 Connect the steer sensor harness to the main
harness and secure with the cable clamp.
22 Calibrate the steer sensor. Refer to Repair
How to Calibrate the Steer Angle
Procedure,
Sensor
.
78 GS-2669 DC • GS-3369 DC • GS-4069 DC
How to Calibrate the Steer Angle
Sensor
1 Turn the key switch to the ground controls
position and pull out the red Emergency Stop
button to the on position at the platform
controls.
2 Press and hold the ground control scroll up
and scroll down buttons.
1 scroll down button
2 enter button
3 scroll up button
4 escape button
5 LCD display
3 Pull out the red Emergency Stop button to the
on position at the ground controls.
Result: The ground controls LCD display will
show the following:
November 2016
Part No. 1272220GT