Genie GS-2669 DC Service And Repair Manual page 88

November 2016
10 Remove the steer sensor assembly retaining
fasteners. Remove the steer sensor assembly
from the yoke.
11 Set the spacer plate aside.
1 steer sensor cover
2 spacer plate
3 steer sensor bracket
4 cable restraint
5 steer sensor
6 steer sensor spacer
7 steer sensor mounting plate
Part No. 1272220GT GS-2669 DC • GS-3369 DC • GS-4069 DC
Steer Axle Components
12 Pull the sensor harness through the cable
restraint and sensor bracket.
13 Remove the retaining fasteners that secure
the steer sensor and the sensor spacer to the
mounting plate. Remove the steer sensor.
14 Install the new steer sensor.
15 Install the steer sensor assembly to the yoke.
16 Rotate the tie rod pivot pin until it is
approximately 90° from the mounting tab on
the tie rod.
Service and Repair Manual
77