Genie GS-2669 DC Service And Repair Manual page 86

November 2016
2 Disconnect the connector with the green/black
wire from the oscillate right coil (item 2) and
swap it with the connector with the blue wire
from the steer right coil (item 3).
1 Green
2 Green/Black
3 Blue
4 Blue/Black
3 Disconnect the connector with the green wire
from the oscillate left coil (item 1) and swap it
with the connector with the blue/black wire
from the steer left coil (item 4).
Part No. 1272220GT GS-2669 DC • GS-3369 DC • GS-4069 DC
Steer Axle Components
4 Turn the key switch to platform control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
5 Slowly drive the machine in a safe direction
and activate steer right.
Result: The right oscillate cylinder will extend
and the left oscillate cylinder will retract.
6 Slowly drive the machine in a safe direction
and activate steer left.
7 Turn the key switch to the off position.
8 Swap the connectors back to the correct coils
using steps 2 an 3 as a reference. Continue to
Check the Steering.
Check the Steering
1 Turn the key switch to platform control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
2 Activate steer right and verify the machine
steers to the right.
3 Activate steer left and verify the machine
steers to the left.
4 Test the axle oscillate. Refer to Maintenance
Test the Oscillate Axle
Section,
Service and Repair Manual
.
75