Steer Axle Components; Yoke Assembly - Genie GS-2669 DC Service And Repair Manual

November 2016
Steer Axle Co mpon ents
8-1 Yoke As sem bly
8-1

Yoke Assembly

How to Remove the Yoke
1 Chock both sides of the wheels at the
non-steer end of the machine.
2 Center a lifting jack under the drive chassis at
the steer end of the machine.
3 Loosen the wheel lug bolts. Do not remove
them.
4 Raise the machine approximately 2 inches / 5
cm. Place blocks under the chassis for
support.
Crushing hazard. The chassis
will fall if not properly supported.
5 Remove the wheel lug bolts. Remove the tire
and wheel assembly.
6 Support and secure the yoke and assembly
with a lifting device.
Part No. 1272220GT GS-2669 DC • GS-3369 DC • GS-4069 DC

Steer Axle Components

Left side yoke:
7 Remove the retaining fasteners from the tie
rod pivot pin.
1 upper king pin
2 tie rod pivot pin
3 lower king pin
4 steer sensor assembly
5 yoke assembly
8 Use a small pry bar to move the pivot pin down
enough to clear the steer sensor assembly.
9 Remove the steer sensor actuator and spring
from the tie rod pivot pin and set aside.
10 Remove the steer sensor assembly and set it
aside.
11 Using a soft metal drift pin and a mallet, drive
the pivot pin up to remove it.
Service and Repair Manual
71