How To Adjust The Steer Relief Valve - Genie GS-2669 DC Service And Repair Manual

November 2016
How to Adj ust the Steer R elief Valve
How to Adjust the Steer Relief
Valve
Note: Perform this procedure with the machine in
the stowed position.
1 Connect a 0 to 5000 psi / 0 to 350 bar
pressure gauge to test port #1 (TP1) on the
function manifold.
2 Remove the platform controls from the
platform and place the controls near the
function manifold on the hydraulic tank side of
the machine.
3 Turn the key switch to platform control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
4 Steer the machine fully to the right or left and
hold. Note the pressure reading on the
pressure gauge. Refer to Specifications,
Hydraulic Components Specifications
5 Use a wrench to hold the steer relief valve and
remove the cap.
6 Adjust the internal hex socket. Turn it
clockwise to increase the pressure or
counterclockwise to decrease the pressure.
Install the relief valve cap.
Tip-over hazard. Do not adjust
the relief valve higher than
specified.
7 Repeat this procedure beginning with step 4 to
confirm the relief valve pressure.
Part No. 1272220GT
.
GS-2669 DC • GS-3369 DC • GS-4069 DC
8 Remove the pressure gauge.
1 test port #1
2 steer relief valve
Service and Repair Manual
Manifolds
53