Wear Pads - Genie GS-2669 DC Service And Repair Manual

Service and Repair Manual
Scissor Components
3-4 W ear Pads
3-4

Wear Pads

How to Replace the Scissor Arm
Wear Pad
Platform Scissor Arm Slider Blocks:
1 Remove the platform. Refer to Repair
How to Remove the Platform
Procedure,
2 Remove the slider blocks and discard.
3 Install the slider blocks.
Note: When installing the platform the drill holes in
the slider blocks must be on the top and bottom.
4 Install the platform.
Chassis Scissor Arm Wear Pads:
1 Attach a lifting strap from a suitable lifting
device to the ladder at the non-steer end of the
machine. Support the ladder. Do not apply
lifting pressure.
28
.
GS-2669 DC • GS-3369 DC • GS-4069 DC
2 Remove the fasteners securing the ladder to
the chassis. Remove the ladder from the
machine and set aside.
Crushing hazard. The ladder
could fall if not properly
supported when the fasteners
are removed from the machine.
3 Using an overhead lifting device attach a strap
to the #1 inner arm at the non-steer end of the
machine.
Note: The overhead lifting device and strap must
be capable of supporting 5000 lbs / 2268 kg.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not
properly supported.
4 Raise the linkage assembly slightly with the
overhead lifting device just enough to take
pressure off of the slider feet.
November 2016
Part No. 1272220GT