KTM 400 EXC AUS 2011 Repair Manual page 97

13/BRAKE SYSTEM
- Pull off dust cap. and connect a conventional suction device (workshop equip-
ment).
- Loosen bleeder screw. and extract the old brake fluid.
• Info
I
During suction. always ensure that the reservoir is filled with a sufficient
amount of new brake fluid.
- Tighten the bleeder screw. Remove the suction device and mount the dust cap.
- Add brake fluid to level •.
I
Brake fluid DOT 41 DOT 5.1 ( .. p. 250)
- Mount the screw cap with the membrane and the O-ring.
- Activate the foot brake lever until a firm pressure point is achieved.
• Info
I
Clean up overflowed or spilt brake fluid immediately with water.
97
13/BRAKE SYSTEM
- Pull off dust cap. and connect a conventional suction device (workshop equip-
ment).
- Loosen bleeder screw. and extract the old brake fluid.
• Info
I
During suction. always ensure that the reservoir is filled with a sufficient
amount of new brake fluid.
- Tighten the bleeder screw. Remove the suction device and mount the dust cap.
- Add brake fluid to level •.
I
Brake fluid DOT 41 DOT 5.1 ( .. p. 250)
- Mount the screw cap with the membrane and the O-ring.
- Activate the foot brake lever until a firm pressure point is achieved.
• Info
I
Clean up overflowed or spilt brake fluid immediately with water.
97