KTM 400 EXC AUS 2011 Repair Manual page 174

31/CARBURETOR
174
- Connect the plus cable 01 the multi meter to the yellow (ye) cable and the ground
cable to the black (bl) cable 01 the throttle position sensor connector.
- Measure the variable throttle position sensor resistance R
n ,.
• Info
I
The throttle slide must be in the basic position.
-
Unscrew screw •. Adjust the throttle valve sensor. by turning to the calculated
value.
- Tighten screw •.
Guideline
Screw, throttle valve sensor
M5
- Check the variable throttle position sensor resistance Rwagain.
• II the measured value is outside of the calculated value:
- Repeat the adjustment procedure.
3.5 Nm
(2.58 Ibl
tt)
31/CARBURETOR
174
- Connect the plus cable 01 the multi meter to the yellow (ye) cable and the ground
cable to the black (bl) cable 01 the throttle position sensor connector.
- Measure the variable throttle position sensor resistance R
n ,.
• Info
I
The throttle slide must be in the basic position.
-
Unscrew screw •. Adjust the throttle valve sensor. by turning to the calculated
value.
- Tighten screw •.
Guideline
Screw, throttle valve sensor
M5
- Check the variable throttle position sensor resistance Rwagain.
• II the measured value is outside of the calculated value:
- Repeat the adjustment procedure.
3.5 Nm
(2.58 Ibl
tt)