Table of Contents
Advertisement
31/CARBURETOR
171
-
Position the float chamber and adjusting screw.
-
Mount screws 41 but do not tighten yet.
-
Insert throttle slide. with throttle slide roller. and the throttle slide plate into
throttle slide arm. and position it in the carburetor.
-
Position the needle clip on the jet needle.
Guideline
Needle position (XC-W SIX DAYS)
1st position from top
Needle position (53D EXC USA)
3rd position from top
Needle position (45D EXC EU/AUS,
4th position from top
45D EXC SIX DAYS, 45D EXC USA)
Needle position (53D EXC EUiAUS,
5th position from top
53D EXC SIX DAYS, all 4DD models)
-
Insert the jet needle.
-
Mount and tighten screw. or slide stop. with the spring and washer.
Guideline
Needle screw/slide stop
-
Mount and tighten
screw •.
Guideline
Screw, throttle slide arm
M4
M8
2
Nm
(1.5 Ibf
ft)
3.5 Nm
(2.58 Ibf
tt)
Loctit'" 243
111
-
Position the throttle slide cover with the gasket. Mount and tighten screws •.
Guideline
1 Other screws, carburetor
1 M4
12 Nm (1.5 Ibf
tt)
-
Check/set the throttle slide opening.
(r
p. 172)
-
Check/adjust the accelerator pump.
(
r
p. 173)
-
Position seal ring . , membrane. and spring •.
•
Info
I
The label on the membrane must be visible when the membrane is
mounted.
-
Position seal ring. in the accelerator pump cover with the rounded side facing
out.
31/CARBURETOR
171
-
Position the float chamber and adjusting screw.
-
Mount screws 41 but do not tighten yet.
-
Insert throttle slide. with throttle slide roller. and the throttle slide plate into
throttle slide arm. and position it in the carburetor.
-
Position the needle clip on the jet needle.
Guideline
Needle position (XC-W SIX DAYS)
1st position from top
Needle position (53D EXC USA)
3rd position from top
Needle position (45D EXC EU/AUS,
4th position from top
45D EXC SIX DAYS, 45D EXC USA)
Needle position (53D EXC EUiAUS,
5th position from top
53D EXC SIX DAYS, all 4DD models)
-
Insert the jet needle.
-
Mount and tighten screw. or slide stop. with the spring and washer.
Guideline
Needle screw/slide stop
-
Mount and tighten
screw •.
Guideline
Screw, throttle slide arm
M4
M8
2
Nm
(1.5 Ibf
ft)
3.5 Nm
(2.58 Ibf
tt)
Loctit'" 243
111
-
Position the throttle slide cover with the gasket. Mount and tighten screws •.
Guideline
1 Other screws, carburetor
1 M4
12 Nm (1.5 Ibf
tt)
-
Check/set the throttle slide opening.
(r
p. 172)
-
Check/adjust the accelerator pump.
(
r
p. 173)
-
Position seal ring . , membrane. and spring •.
•
Info
I
The label on the membrane must be visible when the membrane is
mounted.
-
Position seal ring. in the accelerator pump cover with the rounded side facing
out.
Advertisement
Table of Contents
