Dot1X Default - Cisco Catalyst 3550 Command Reference Manual

Chapter 2 Cisco IOS Commands

dot1x default

Use the dot1x default interface configuration command to reset the configurable 802.1X parameters to
their default values.
Syntax Description
This command has no arguments or keywords.
Defaults
These are the default values:
•
•
•
•
•
•
•
•
•
Command Modes Interface configuration
Command History Release
12.1(8)EA1
12.1(14)EA1
Examples
This example shows how to reset the configurable 802.1X parameters on an interface:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands Command
show dot1x
interface-id]
78-11195-09
dot1x default
The per-interface 802.1X protocol enable state is disabled (force-authorized).
The number of seconds between re-authentication attempts is 3600 seconds.
The periodic re-authentication is disabled.
The quiet period is 60 seconds.
The retransmission time is 30 seconds.
The maximum retransmission number is 2 times.
The host mode is single host.
The client timeout period is 30 seconds.
The authentication server timeout period is 30 seconds.
Modification
This command was first introduced.
This command was changed to the interface configuration mode.
Description
[interface Displays 802.1X status for the specified interface.
Catalyst 3550 Multilayer Switch Command Reference
dot1x default
2-67