Cisco Catalyst 3550 Command Reference Manual page 600

debug autoqos
4d22h: wrr-queue cos-map 1 0 1 2 4
4d22h: wrr-queue cos-map 3 3 6 7
4d22h: wrr-queue cos-map 4 5
4d22h: priority-queue out
Switchconfig-if)# interface gigabitethernet0/1
Switch(config-if)# auto qos voip cisco-phone
Switch(config-if)#
4d22h:interface GigabitEthernet0/1
4d22h: mls qos trust device cisco-phone
4d22h: mls qos trust cos
4d22h: wrr-queue bandwidth 20 1 80 0
4d22h: wrr-queue queue-limit 80 1 20 1
4d22h: no wrr-queue cos-map
4d22h: wrr-queue cos-map 1 0 1 2 4
4d22h: wrr-queue cos-map 3 3 6 7
4d22h: wrr-queue cos-map 4 5
4d22h: priority-queue out
Switch(config-if)#
Related Commands Command
auto qos voip
show auto qos
show debugging
Catalyst 3550 Multilayer Switch Command Reference
B-4
Description
Configure auto-QoS for voice over IP (VoIP) within a QoS domain.
Displays the configuration applied and the new defaults in effect when
auto-QoS is enabled.
Displays information about the types of debugging that are enabled. For syntax
information, select Cisco IOS Configuration Fundamentals Command
Reference For IOS Release 12.1 > Cisco IOS System Management
Commands > Troubleshooting Commands.
Appendix B Debug Commands
78-11195-09