Cisco Catalyst 3550 Command Reference Manual page 252

setup express
Examples
This example shows how to enable Express Setup mode:
Switch(config)# setup express
You can verify that Express Setup mode is enabled by pressing the Mode button:
•
•
Caution If you hold the Mode button down for a total of 10 seconds, the configuration is deleted, and the switch
reboots.
This example shows how to disable Express Setup mode:
Switch(config)# no setup express
You can verify that Express Setup mode is disabled by pressing the Mode button. The mode LEDs only
turn solid green or begin blinking green if Express Setup mode is enabled on the switch.
Related Commands Command
clear setup express
show setup express
Catalyst 3550 Multilayer Switch Command Reference
2-226
On an unconfigured switch, the mode LEDs begin blinking green after 2 seconds.
On a configured switch, the mode LEDs turn solid green after a total of 10 seconds.
Description
Exits Express Setup mode without saving the configuration.
Displays if Express Setup mode is active on the switch.
Chapter 2 Cisco IOS Commands
78-11195-09