Cisco Catalyst 3550 Command Reference Manual page 306

show interfaces
This is an example of output from the show interfaces flowcontrol command.
in this display.
Switch# show interfaces flowcontrol
Port
-----
Fa0/1
Fa0/2
<output truncated>
Gi0/1
Gi0/2
Po1
Po2
Po59
Po60
Po63
Po64
Table 2-19 show interfaces flowcontrol Field Descriptions
Field
Port
Send FlowControl
Admin
Oper
Receive FlowControl
Admin
Oper
RxPause
TxPause
On
Off
Desired
Unsupp.
This is an example of output from the show interfaces gigabitethernet0/9 pruning command when
pruning is enabled in the VTP domain:
Switch# show interfaces gigibitethernet0/9 pruning
Port
Gi0/9
Port
Gi0/9
Catalyst 3550 Multilayer Switch Command Reference
2-280
Send FlowControl Receive FlowControl
admin oper admin
-------- -------- -------- --------
Unsupp. Unsupp. off
Unsupp. Unsupp. off
desired off off
desired off off
Unsupp. Unsupp. off
Unsupp. Unsupp. off
Unsupp. Unsupp. off
Unsupp. Unsupp. off
Unsupp. Unsupp. off
Unsupp. Unsupp. off
Vlans pruned for lack of request by neighbor
3,4
Vlans traffic requested of neighbor
1-3
RxPause TxPause
oper
------- -------
off 0 0
off 0 0
off 0 0
off 0 0
off 0 0
off 0 0
off 0 0
off 0 0
off 0 0
off 0 0
Description
Displays the port name.
Displays the administrative (configured) setting for the flow
control send mode.
Displays the operational (running) setting for the flow control
send mode.
Displays the administrative (configured) setting for the flow
control receive mode.
Displays the operational (running) setting for the flow control
receive mode.
Displays the number of pause frames received.
Displays the number of pause frames sent.
Flow control is enabled.
Flow control is disabled.
Flow control is enabled if the other end supports it.
Flow control is not supported.
Chapter 2 Cisco IOS Commands
Table 2-19 lists the fields
78-11195-09